Dear customers, we ask you to fill in plaint sheet after master finishes work and make sure that the master sticked on the warranty card. Without a coupon, we do not have any obligations. Read more...

 

Installing of washing machines

Our company offers its services in installation and repair of washing machines. We have been on the market for more than 10 years and during this time have installed and repaired thousands of washing machines. Our experience allows us to safely say that we are able to eliminate any malfunction of your washing machine and install it in accordance with all manufacturer recommendations.

Often, the correct installation of washing machine depends on the quality and duration of its work. If you need a high-quality installation of a washing machine, contact Server Service.

Installing a washing machine is a process that begins with unpacking and removing all shipping seals (such seals are placed in the factory and designed to protect the drum of washing machine from damage during transport).

After removing all seals and locks, it is necessary to check the body of washing machine for deffects and damage. Such deformations occur during inaccurate transportation and, if you don't notice it before switching on, it may cause more serious damage. Even when buying a washing machine in the most reliable store, it is possible to detect such damage on a newly purchased washing machine.

1) Waterpipe connection.

When you install a washing machine, it is necessary to connect a cold water supply to the system. If you have a hydrant water supply hose from sink riser, then branch with tap is installed in front of the water faucet. If in system of supplying water from sink riser (or bath), hard pipes are used - a drainage pipe is installed on the pipe and a separate tap is already placed on it. The washing machine is connected to a water pipe (to a faucet installed on a water pipe) using a flexible hose supplied with the washing machine. Connect the washing machine directly to the water supply system (without the use of a crane) can not be done - this can cause premature failure of the washing machine.

2) Drainage system

Drainage system is necessary for the withdrawal used in washing of water into the sewage system. There are two options: you can install the drain hose on the edge of the sink (bath or toilet) with the hook that comes with washing machine, but this method of connection is inconvenient and requires constant manipulation (the hose will stop you and after each washing you will take it off). To increase the convenience of using the washing machine and the reliability of its operation, the drain hose is recommended to be connected directly to the sewage system. To do this, a tee is connected to sewer pipe from the sink or bath, to which the drain hose of washing machine is connected.

3) Electricity supply.

To connect the appliance to washing machine, it is necessary to install a grounded outlet and conduct a separate wire from switchboard to it. Electrical panel for this outlet must be installed special separate fuse for 16A. This should be done by an expert with a good knowledge of the electricians.

4) Set the car level. This is necessary for the quiet operation of washing machine. Incorrect installation of washing machine can cause its pre-time breakdown.

5) Make a test washing
Test washing is usually done without laundry (or with a minimum amount of laundry), use the amount of detergent and rinse aid necessary for washing.

The connection of washing machines requires a mandatory and professional connection to utilities, such as a water supply system, a sewage system and an electrical network. The consequences of improper connection can be the most disastrous, so we highly recommend not to install a washing machine for people who do not have practical experience in this matter, but we advise you to apply only to specialists, to use qualified plumbing services.

Our company Server Service offers you fast and high-quality installation of washing machines.